Reloading component score.

[Vaquero]

I went down to one of the few places that stocks supplies today.
Scored a little powder, was getting low on the 3031, and why not grab another 2400 while I was there and it was too.
Taxes included $154 otd.

20230211_130954.jpg (3.08 MiB) Viewed 2150 times

RP

[Headhog]

Good score. Now you should be ready for some magnum handgun loads and rifle too. Time for fun!

Paul

[Hatchdog]

Drooling over that 2400 right here, that and most other Alliant powders are not to be found around here.

[BigAl52]

Was the IMR powder more than the 2400

[Vaquero]

He had 2 pounds of it, I already had 2+ lbs at home.
So I just grabbed the one, and yes Alliant powders are SLIM to none around here also.
I'd love to see some red dot on a shelf.

RP

[BigAl52]

He had 3 pounds of it, I already had 2+ lbs at home.
So I just grabbed the one, and yes Alliant powders are SLIM to none around here also.
I'd love to see some red dot on a shelf.

RP

8lber on the shelf down here at Corpus at the gun club.

[Vaquero]

Was the IMR powder more than the 2400

Same price, $46.99 + uncle Sam's part.
IMR 4350 was $62.99 +, but
IMR 4198 was $49.99
Most of the Win. and Hodgdon pistol powders were $36.99+

RP

[Vaquero]

He had 3 pounds of it, I already had 2+ lbs at home.
So I just grabbed the one, and yes Alliant powders are SLIM to none around here also.
I'd love to see some red dot on a shelf.

RP

8lber on the shelf down here at Corpus at the gun club.

Red dot?

RP

[BigAl52]

Have any of you Pugnose lovers tried that load in one of your 357 mag pistols? They have one heck of a bark out of my Blackhawks

[BigAl52]

He had 3 pounds of it, I already had 2+ lbs at home.
So I just grabbed the one, and yes Alliant powders are SLIM to none around here also.
I'd love to see some red dot on a shelf.

RP

8lber on the shelf down here at Corpus at the gun club.

Red dot?

RP

Yes sir Red Dot

[Vaquero]

Have any of you Pugnose lovers tried that load in one of your 357 mag pistols? They have one heck of a bark out of my Blackhawks

Al, last week when GFK was looking at the new King Cobras, I pulled mine out and dusted it off. Been a good while since I last shot it.
I grabbed 6 of those and ran them through it from like 10 yds. I didn't think it was all that bad. And considering how long since I last put rounds through it I did ok.

20230203_122337.jpg (3.57 MiB) Viewed 1344 times

RP

[BigAl52]

Im thinkin your King Cobra has a little more weight than the Blackhawk

[Vaquero]

How long of a barrel on your BH?

RP

[BigAl52]

The one I shot it outa was the 4 5/8. It was about like a full power 158 load. On a side note just bought a Rock Island 1911 in 40 to good a deal to pass up

[Vaquero]

I took it and the 41 mag BH with a 6.5" barrel out I can't really tell much difference in their weight.
Just looked up the specs, the KC was 28 oz, and the 4 5/8s BH is 45 0z.

RP

[Vaquero]

The one I shot it outa was the 4 5/8. It was about like a full power 158 load. On a side note just bought a Rock Island 1911 in 40 to good a deal to pass up

I liked the 45 acp RI I had, and this High Standard I recently bought was made at the same facility.
I'm going to put some rounds through it here after while.

RP

[BigAl52]

I like 1911 even if there brass throwers they are great guns to shoot. I have so much 40 brass and powder I might as well shoot some of it up. I have a Smith M&P 40 but its one of the older ones and it has a terrible trigger. Need to check into a different one.

[fortyshooter]

A lucky dog scoring that Alliant 2400 !! None around the local shops but I have some.

[Pitchman1968]

and, no shipping charge or hazmat fees.

[Rifletom]

Have any of you Pugnose lovers tried that load in one of your 357 mag pistols? They have one heck of a bark out of my Blackhawks

Yes they do!