Henry Rifle Forums

Well here it is. I think it turned out better than I was expecting.

All from Henrys Rice lake,WI plant Yes they'll interchange. Just the finishes are different. To have different tooling for the all weather would not be cost effective

I must ask why swap beautiful walnut for plastic coating ?

Are there tutorials on how to remove the foregrip? I tried it before because the one now keeps coming loose but it was imposible.

The foreend cap has a screw on each side.

Thanks Oldbrass. Even after the cap is removed, the piece where the cap screws go prevents the foregrip from moving forward enough to come out of the receiver. I did get it off today though. I put a plastic wedge between the barrel and the mag tube and I was able to push the piece out. Then it was just a matter of pulling the grip off. I’ll post pictures when the project it’s done. I should have it done in a couple of weeks. They’re out of stock for the stock sets. They said they should have them by next week.

You could probably sell the original stock here on the forum or use for trade fodder..Is the furniture in good condition?

I'm betting it will look very good.
I know it's suppose to be weather resistant, but I don't care for those Black plastic stocks.
Can't wait to see it.

RP

Yeah I can’t wait to get it done. They’re out of stock but they said by next week they’ll be back in stock. Yeah Vaquero I’m not a fan of the plastic stocks with mloks and rails and stuff like that. I think the wood stock from the AW will be a nice look on the BBS