Henry Rifle Forums

I sold my 2011 Mustang I got it new for my birthday in 2011 and it only had 6,952 on it when I sold it monday and it has NEVER seen a drop of rain . It went from 0 to 170 mph in under 26 seconds and got 27 mpg on the 93 octane race tune . I enjoy driving my 2013 Miata more then the Mustang and I had a chance to sell it to a good home .

Definitely is beautiful!

I got to touch it once but John wouldn't let me drive it.

I had a 1973 with a 351 Cleveland in it. It was a great car not the same body style but I have always liked the mustangs. Just not practical for me right now to many other toys like a boat four wheeler and mulitple Henrys. Very neat car. Al

Wow!! That is beautiful!

I bet it sounds fantastic when it's angry, too!

Good looking car.

Thanks for the pics, TGR. That really is a beautiful car! And, I'm sure it went to a good home -- one with a garage!!!

Beautiful car. I'm glad it went to a good home.

very nice indeed .... 170

JEBar wrote:very nice indeed .... 170

As Joe Walsh sang " goes 185, I lost my license now I don't drive"

Here is video of 2011 mustang going from 0 to 160 in under 26 second . My mustang was a little faster . I could go from 0 to 170 in 26 second and like the video I use only 5 of the 6 gears too . My red line was 7,500 at 170 mph and my car needs a splitter for more down force on front and taller rear wing to drive faster then 170 mph .

https://www.youtube.com/watch?v=l8_32TUmbLc

Man, you've got to lurve that 8 cylinder growl!

I had one just a bit older than yours. 2006. I installed my own shaker hood system. Bad little stang!

Nice looking ride .....My car was less then 3 mo's old . When I cut the hole in hood out for the Shaker system . I was going to super charge the engine but the Coyote engine ran so good with only a few upgrades I didn't think the supercharger was needed anymore . . I should have got a convertible like yours and maybe I wouldn't have got the Miata .

Yeah, drilling that first hole is the hardest. After that it's like...ok, we're committed. Let's get to it.










A perfect fit.

Bish1309 wrote:Yeah, drilling that first hole is the hardest. After that it's like...ok, we're committed. Let's get to it.


]

Your hood was setup for that Shaker Scoop . Here is the piece I cutout and you can see the 2 braces I cut out .

I C that.