Found my pet load for my 45-70
Posted: Sat Sep 16, 2017 9:53 pm
I was having the worst time getting any decent accuracy from my 45-70 with hardcast from Bullet Barn using their 350 gr plain base. They advertised 0.459" but I measured 0.458" and 0.457". Not one measured 0.459". The best load was using IMR 4198 with 30gr but they only averaged 1257 fps, averaged 1" - 1.5" groups @ 50 yards plus I was getting lead fouling.
I ordered a batch of 350 gr hardcast with gas check from Jet Bullets and they all measured 0.459" as advertised. Switched to IMR 3031 and worked up my loads till I was happy with the results at 50 yards which is my hunting range and used a VX-3i 1.5 - 5x Leupold scope. Also happy to mention there was no lead fouling even after 50 rounds of testing.
For my testing I waited about 10 minutes in between shots for the barrel to cool down for that cold bore shot. Thank goodness for my cabin up north and no neighbors around.
- 350 gr (sorted and actual weight - 351 gr) Jet hardcast bullets with gas check @ 0.459"
- 45 gr of IMR 3031
- Remington brass
- CCI Larger Rifle Primers
- Average 1581 fps
- 1/2" @ 50 yards
Finally!!





I ordered a batch of 350 gr hardcast with gas check from Jet Bullets and they all measured 0.459" as advertised. Switched to IMR 3031 and worked up my loads till I was happy with the results at 50 yards which is my hunting range and used a VX-3i 1.5 - 5x Leupold scope. Also happy to mention there was no lead fouling even after 50 rounds of testing.
For my testing I waited about 10 minutes in between shots for the barrel to cool down for that cold bore shot. Thank goodness for my cabin up north and no neighbors around.
- 350 gr (sorted and actual weight - 351 gr) Jet hardcast bullets with gas check @ 0.459"
- 45 gr of IMR 3031
- Remington brass
- CCI Larger Rifle Primers
- Average 1581 fps
- 1/2" @ 50 yards
Finally!!






