What did you do at your reloading bench today?

[Hatchdog]

You’ve been busy Grouse

[DsGrouse]

sized my annealed 6.5x55 brass, it's going in for a trim in a few moments. I plan to load some 140 grn target loads, and 160grn subsonic loads.

[DsGrouse]

Loaded 6.5x55 Swede yesterday.
150ish rounds of 160 grn subs
150ish rounds of 140grn subs
150-ish rounds of 140-grain supers
100-ish rounds of 150 grn supers.

For the subs i used TiteGroup. 9.2 and 9.0 grains respectively. The supers I used were 4064 in a couple of different weights.

All the brass for the subs was bought used. I had to toss about 10 pieces. I annealed, sized, and trimmed them yesterday. The supers were all new brass.

Shooting subs out of the cases stretches the necks something fierce, so a full length resize is necessary. The annealing made a noticeable difference in sizing and trimming.

[Vaquero]

Nothing here, but...

FB_IMG_1773890517910.jpg (42.45 KiB) Viewed 151 times

RP

[The Happy Kaboomer]

Nothing............But I unloaded 4 boxes of 12 ga at the sporting clays range........

[DsGrouse]

Oh that sounds fun

[Hatchdog]

Nothing............But I unloaded 4 boxes of 12 ga at the sporting clays range........

[DsGrouse]

Loaded a couple hundred rounds of Sierra 165-grain 308, and about the same in Swiss P 167-grain ammo. Both shot exceptionally well.