A little unplanned upgrade this morning. Site is working ok it seems.
Project in the works....
-
fortyshooter
- Ranch Foreman
- Posts: 7058
- Joined: Sat Dec 09, 2017 10:37 am
- Location: Va.
Project in the works....
Hope I can get it done before Christmas!
You do not have the required permissions to view the files attached to this post.
Re: Project in the works....
Uh-ooo, that’s going to leave a mark. 
Assume your cutting down the barrel length? Or a groove for some addition?
Assume your cutting down the barrel length? Or a groove for some addition?
-
fortyshooter
- Ranch Foreman
- Posts: 7058
- Joined: Sat Dec 09, 2017 10:37 am
- Location: Va.
Re: Project in the works....
Possible threading a rifle barrel?
-
JEBar
- Town Marshal / Deputy Admin
- Posts: 20342
- Joined: Sun Mar 20, 2016 10:58 pm
- Location: central NC
Re: Project in the works....
kudos for being able to undertake such a project ... no way I could/would do so
Re: Project in the works....
I would….I got me a dull hacksaw and a broken chisel. Bring it on……..
Forty, I had the pleasure of working with skilled machinists (note, working with not alongside
) and it is just amazing to watch what can be done with the knowledge, skill and equipment these folks have.-
fortyshooter
- Ranch Foreman
- Posts: 7058
- Joined: Sat Dec 09, 2017 10:37 am
- Location: Va.
Re: Project in the works....
Well the basics are done and just waiting on a couple parts. Think it will be a cool revolver when finished and of course a range review.
Stay tuned!
Stay tuned!